POWER + TRUST + POSITION

Connected electric mobility

Coordinate auxiliary power, authenticated batteries and location telemetry in light electric vehicle electronics.

Discuss your design
SYSTEM DESIGN PERSPECTIVE FuuVeXia Engineering
Connected electric mobility
Original concept visualization
SYSTEM VIEW

The complete signal path.

Conceptual functional architecture. External components and interfaces depend on the final system design.

01

BATTERY PACK

→
02

POWER + IDENTITY

→
03

VEHICLE CONTROLLER

→
04

LOCATION SERVICES

Previous functional flow · retained
01BATTERY PACK
→
02POWER + IDENTITY
→
03VEHICLE CONTROLLER
→
04LOCATION SERVICES
01 / ENGINEERING

Map the voltage domains

Motor power, auxiliary rails and always-on electronics have different noise and duty-cycle requirements. Evaluate the power controller in its intended supporting rail rather than assuming it is a traction inverter. Validate input transients and ground offsets on the complete harness.

02 / ENGINEERING

Plan battery replacement from day one

Battery authentication must accommodate legitimate pack swaps, service replacements and account transfer. Separate pack identity from user identity. An offline authorization policy should be explicit and consistent with the vehicle’s safety requirements.

03 / ENGINEERING

Validate installation and environment

Water ingress, vibration, antenna shadowing and electromagnetic emissions are system concerns. Industrial temperature targets do not establish automotive qualification. Obtain the applicable qualification evidence and change-control commitments before production sourcing.

DESIGN REVIEW

Make the requirements measurable.

Design considerationEvaluation focus
RailsTraction, auxiliary and standby domains
Battery workflowSwap, return, revoke and replace
TrackingAntenna placement and reporting duty cycle
QualificationApplication-specific evidence required

¹ Where shown: preliminary portfolio target, not a guaranteed production limit.

Before design-in

  1. Capture startup current and standby drain.
  2. Verify authorized battery swaps without a network.
  3. Measure RF performance with the enclosure assembled.
ENGINEER WHAT COMES NEXT

Your next design.
Our next conversation.

Talk to engineering